This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Error in HA Management Log

James Shakour over 4 years ago

After upgrading to 9.702-1 I noticed the following error in the HA log...

repctl[7121]: [i] recheck(1057): got ALRM: replication recheck triggered Setup_replication_done = 1

What does this error mean? Everything is performing normally.

I am running an SG310 (Master / Slave) in HA.

This thread was automatically locked due to age.

Parents

0 dirkkotte over 4 years ago

Do you get this message repeatedly?
Try to restart the slave.
Check reporting/hardware.
Do you see cpu charts for local and remote device?

Dirk

Systema Gesellschaft für angewandte Datentechnik mbH // Sophos Platinum Partner
Sophos Solution Partner since 2003
If a post solves your question, click the 'Verify Answer' link at this post.
Cancel
Vote Up 0 Vote Down

Cancel
0 James Shakour over 4 years ago in reply to dirkkotte

Yes, a handful every hour.

Yes, I can see the CPU charts for both nodes.

I have not rebooted the slave yet.
Cancel
Vote Up 0 Vote Down

Cancel
0 James Shakour over 4 years ago in reply to James Shakour

I have rebooted the slave and the error still persists.
Cancel
Vote Up 0 Vote Down

Cancel
0 dirkkotte over 4 years ago in reply to James Shakour

Please check system-status within HA. active/ready = OK

I've checked some other (perfect running) HA systems and see the same messages.

Here is an explanation from sophos staff.

community.sophos.com/.../high-availability-log-entries-since-9-407

Dirk

Systema Gesellschaft für angewandte Datentechnik mbH // Sophos Platinum Partner
Sophos Solution Partner since 2003
If a post solves your question, click the 'Verify Answer' link at this post.
Cancel
Vote Up 0 Vote Down

Cancel
0 James Shakour over 4 years ago in reply to dirkkotte

Thanks Dirk!

System status is good to go!

I saw that post before but the fact that it was for 9.4xx and not 9.7xx got me wondering is all.

Thanks again!
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 James Shakour over 4 years ago in reply to dirkkotte

Thanks Dirk!

System status is good to go!

I saw that post before but the fact that it was for 9.4xx and not 9.7xx got me wondering is all.

Thanks again!
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data