This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Firewall Interfaces in HA Cluster

Hi,

a few weeks ago i enabled an additional WAN Interface for Internet Uplink Balancing and Failover on our UTM 9 HA Cluster.
Yesterday i did a restart of the main node and second node took over.
After logging in i noticed the second node misses the additional interface plus Uplink Balancing Configuration.
Isn't it supposed to have the exact same configuration?
The location is remote and i can't just delete and rejoin the second node.
Any idea what's wrong and what i can do to replicate the interface configuration?

cheers,

Daniel

This thread was automatically locked due to age.

0 BAlfson over 5 years ago

Hallo Daniel,

Are you sure that the second interface is connected in the remote site? It might suffice to fail back to the other node, power down the second node, connect the NIC on the second node and then power it back up. If not, I would get Sophos Support involved.

Cheers - Bob

Sophos UTM Community Moderator
Sophos Certified Architect - UTM
Sophos Certified Engineer - XG
Gold Solution Partner since 2005

MediaSoft, Inc. USA
Cancel
Vote Up 0 Vote Down

Cancel