Thread Info
  • Locked Locked
  • Replies 4 replies
  • Subscribers 2 subscribers
  • Views 17305 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Ethernet Bridge

DustyPark

I'm trying to bridge my wlan interface to my eth0 interface but I can't get the wireless interface to show in the list of NICs to add to the bridge. I've tried the wlan interface as seperate and bridged to AP lan. Any ideas?



This thread was automatically locked due to age.
  • in reply to Scott_Klassen
    I tried that, if I'm understanding it correctly. I removed all wireless networks and added a new one setting the client traffic to "bridge to AP LAN" but still no luck.
  • The wlan0-Interface appears only in the interfaces when you chose "seperated zone" in the wireless network.
    When you choose "AP to LAN" you don't need another Interface....

  • I had the same issue. I upgraded to the latest firmware then reset to factory defaults. After that my wireless interface did show up under Bridge Selected NICs.

    Also I found the KB article slightly incomplete. In my case I wanted to simply bridge the wifi to the existing Internal interface. So rather than create a new interface, I changed Internal type from Ethernet to Ethernet bridge.

    For completeness these are the steps I followed:
    Upgrade firmware (tested on 9.351-3)
    - Management > Up2Date

    Reset to factory defaults
    - Management > System settings > Reset Configuration
    - Click Run Factory Reset Now

    Power on UTM

    Configure basic UTM
    - Run wizard, or
    - Manually create Internal, External interfaces, Internal DHCP, NAT Masq Internal to External, Basic firewall rules for DNS and Web surfing
    - Make sure you can surf the web from a wired connection

    Make a backup (it's much quicker to restore while experimenting)
    - Management Backup/Restore

    Create wireless network as a Bridge to AP LAN
    - Wireless Protection > Global Settings
    - Enable Wireless Protection status
    - Enable Skip automatic configuration
    - Click Apply
    - Wireless Protection > Wireless Networks
    - Click New Wireless Network
    - Enter Network name, ssid and encryption mode details
    - Under Client traffic select Bridge to AP LAN

    Convert Internal to a bridge interface
    - Interfaces and Routing > Interfaces > Interfaces
    - Click Edit on the Internal interface
    - Under Type select Ethernet Bridge
    - Check the new wireless network (along with the Internal eth0 interface)
    - Expand Advanced Bridge and check Allow ARP Broadcasts
    - Click Save

    Associate the Wireless network to the Internal AP
    - Wireless Protection > Access Points > Overview
    - Click Edit on the internal wireless card (LocalWifi0)
    - Expand Wireless Networks
    - Check the new wireless network
    - Click Save


Unfiltered HTML