This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Ethernet Bridge

I'm trying to bridge my wlan interface to my eth0 interface but I can't get the wireless interface to show in the list of NICs to add to the bridge. I've tried the wlan interface as seperate and bridged to AP lan. Any ideas?

This thread was automatically locked due to age.

Parents

Scott_Klassen over 9 years ago

Most likely, community.sophos.com/.../122102 applies.

__________________
ACE v8/SCA v9.3

...still have a v5 install disk in a box somewhere.

http://xkcd.com
http://www.tedgoff.com/mb
http://www.projectcartoon.com/cartoon/1
Cancel
Vote Up 0 Vote Down

Cancel
DustyPark over 9 years ago in reply to Scott_Klassen

I tried that, if I'm understanding it correctly. I removed all wireless networks and added a new one setting the client traffic to "bridge to AP LAN" but still no luck.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

DustyPark over 9 years ago in reply to Scott_Klassen

I tried that, if I'm understanding it correctly. I removed all wireless networks and added a new one setting the client traffic to "bridge to AP LAN" but still no luck.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data