This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

How do I create a Bridge, LTE (4G) to Ethernet?

I have been using a Dovado Pro (in bridge mode) with a Huawei E3276 for some years and my internet connection use to drop up to 10 times/day.
Reconnecting took up to 10 min.

I just changed to UTM 9 and now my USB modem is quite stable.
Reconnecting only takes a couple of sec.

Next step is to bridge my Huawei E3276 to an Ethernet interface.
I can't seem to find a guide for this.

Just to clarify; the LTE connection is my only internet connection. This is not to be used as fail-over.

I have 2 unused Ethernet interfaces available thanks to the upgrade the other day.
StarTech.com part# USB31000SW
USB-to-Ethernet Gigabit based on ASIX AX88179.

Anyone?

This thread was automatically locked due to age.

Parents

0 Scott_Klassen over 8 years ago

Good enough. The context helps. Fairly easy to create a bridge. It's done at Interfaces & Routing > Bridging > Status. Enable bridging, select the interfaces that will be part of the bridge, then click the create bridge button. If you select an already configured interface for Convert Interface, the bridge will inherit the settings of that interface. I've never tried this and don't have an LTE USB to test with.

__________________
ACE v8/SCA v9.3

...still have a v5 install disk in a box somewhere.

http://xkcd.com
http://www.tedgoff.com/mb
http://www.projectcartoon.com/cartoon/1
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Scott_Klassen over 8 years ago

Good enough. The context helps. Fairly easy to create a bridge. It's done at Interfaces & Routing > Bridging > Status. Enable bridging, select the interfaces that will be part of the bridge, then click the create bridge button. If you select an already configured interface for Convert Interface, the bridge will inherit the settings of that interface. I've never tried this and don't have an LTE USB to test with.

__________________
ACE v8/SCA v9.3

...still have a v5 install disk in a box somewhere.

http://xkcd.com
http://www.tedgoff.com/mb
http://www.projectcartoon.com/cartoon/1
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 nicnet over 8 years ago in reply to Scott_Klassen

I don't have the menu section "Bridging" under "Interfaces & Routing".
Is this something not available in v. 9.351-3 (Home use only license)?

Sub-sections under "Interfaces & Routing" are:
Interfaces
Quality of Service (QoS)
Uplink Monitoring
IPv6
Static Routing
Dynamic Routing (OSPF)
Border Gateway Protocol
Multicast Routing (PIM-SM)
Cancel
Vote Up 0 Vote Down

Cancel