Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 2 replies
  • Subscribers 3 subscribers
  • Views 3204 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Disable Uplink Balancing using CLI

Febrianto Fitranto

Hi all, 

Our network using 2 ISP, we want to distinguish the load manually, so we disable the uplink balancing and configure multipath rule and policy route. But as we monitored the traffic between 2 ISP it seems keep enforce the uplink balancing behind the scenes,,,,

Is there any way to confirm that uplink balancing is not enforced and steps to disable uplink balancing via command line? 

 

Regards,

Febri



This thread was automatically locked due to age.
  • 0

    Hi Febri,

    I think You need the uplink balancing function for the multipath rules to work.

    Please check the multipath rules twice to ensure that the packets You see on the wrong interfaces is matched by the correct multipath rules.

    In most cases the connections originated by the utm itself are not covered by the rule.

    If You are working with policy routing and masquerading is activated on the interface, ensure that there is a corresponding source nat rule for the re-routed packets.

     

    Good Luck!

    Chris.

     

    Sophos Certified Architect (UTM + XG)

  • 0

    Ciao Febri and welcome to the UTM Community!

    If you still need help after Chris' answer, please post pictures of the Edits of your Multipath rules with 'Advanced' open.  Also a picture of the 'Uplink Balancing' tab.

    Cheers - Bob

     
    Sophos UTM Community Moderator
    Sophos Certified Architect - UTM
    Sophos Certified Engineer - XG
    Gold Solution Partner since 2005
    MediaSoft, Inc. USA
Unfiltered HTML