This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

What is normal Exchange 2010 Receive Connector setup for UTM?

How should your receive connector be setup in Exchange 2010 for typical UTM 9 deployment?

See 4 pictures attached.

Is that best practice and correct?

only port 25 or should I add 587?

should the HELO response be my internal name or external MX name?

what about auth and permission groups?

This thread was automatically locked due to age.

Parents

0 BAlfson over 11 years ago

Thanks, the only malware I've gotten in six years was clicking a picture link here several years ago.

If this is an existing Exchange and you're adding the UTM to the mix, I don't think you need to change the Receive Connector, just the smarthost setting in the Send Connector.

Cheers - Bob

Sophos UTM Community Moderator
Sophos Certified Architect - UTM
Sophos Certified Engineer - XG
Gold Solution Partner since 2005

MediaSoft, Inc. USA
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 BAlfson over 11 years ago

Thanks, the only malware I've gotten in six years was clicking a picture link here several years ago.

If this is an existing Exchange and you're adding the UTM to the mix, I don't think you need to change the Receive Connector, just the smarthost setting in the Send Connector.

Cheers - Bob

Sophos UTM Community Moderator
Sophos Certified Architect - UTM
Sophos Certified Engineer - XG
Gold Solution Partner since 2005

MediaSoft, Inc. USA
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data