This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

What is normal Exchange 2010 Receive Connector setup for UTM?

How should your receive connector be setup in Exchange 2010 for typical UTM 9 deployment?

See 4 pictures attached.

Is that best practice and correct?

only port 25 or should I add 587?

should the HELO response be my internal name or external MX name?

what about auth and permission groups?

This thread was automatically locked due to age.

0 BAlfson over 11 years ago

Jason, please edit your post, [Go Advanced] and use the paper clip icon to upload your pictures to this forum. We can't know how secure imgur is or that one of your pictures isn't infected with malware. Thanks.

Cheers - Bob

Sophos UTM Community Moderator
Sophos Certified Architect - UTM
Sophos Certified Engineer - XG
Gold Solution Partner since 2005

MediaSoft, Inc. USA
Cancel
Vote Up 0 Vote Down

Cancel
0 JasonIstre over 11 years ago in reply to BAlfson

Updated with pictures as attachments.
Cancel
Vote Up 0 Vote Down

Cancel
0 BAlfson over 11 years ago

Thanks, the only malware I've gotten in six years was clicking a picture link here several years ago.

If this is an existing Exchange and you're adding the UTM to the mix, I don't think you need to change the Receive Connector, just the smarthost setting in the Send Connector.

Cheers - Bob

Sophos UTM Community Moderator
Sophos Certified Architect - UTM
Sophos Certified Engineer - XG
Gold Solution Partner since 2005

MediaSoft, Inc. USA
Cancel
Vote Up 0 Vote Down

Cancel