This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

No network leds on eth0/1/2 after UTM reinstall

Hi,

I just reinstalled an UTM120 with UTM 9.5 (asg iso).

after successfull installation and reboot, the activity leds of eth0 (LAN) is only active for about 20 seconds (cable inserted) when booting and after that the LED does not show activity (also no LED blinking on the link led).

I only get an activity/link led, when I insert a network cable into eth3 (HA), but cannot connect to the webadmin.

What could be wrong?

This thread was automatically locked due to age.

Parents

0 BAlfson over 7 years ago

Not sure what you mean by "asg iso" as you should use the ssi ISO.

Cheers - Bob

Sophos UTM Community Moderator
Sophos Certified Architect - UTM
Sophos Certified Engineer - XG
Gold Solution Partner since 2005

MediaSoft, Inc. USA
Cancel
Vote Up 0 Vote Down

Cancel
0 MKR74 over 7 years ago in reply to BAlfson

Hi,

The ASG is the non-appliance version. The ssi is for Sophos appliances.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 MKR74 over 7 years ago in reply to BAlfson

Hi,

The ASG is the non-appliance version. The ssi is for Sophos appliances.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data