cannot setup as router

Hi, and welcome to the UTM Community!

First, I would confirm that the modem works and that the DSL service works with your PC connected directly to the modem in routing (not bridged) mode.  Once that works, then, leaving the modem in routing mode, try with the External interface set as 'Type: Ethernet' with 'Dynamic IP' checked.  If that works, put the modem in Bridge mode and configure the UTM's interface with 'Type: DSL (PPPO?)'.  Any better luck?

Cheers - Bob

anyone can help me , what is the problem

What happens if you connect your PC directly to the modem?

Cheers - Bob

direct to modem using diap up no problem , set as router also ok

Did I understand correctly that when you connect the UTM to the modem in router mode (not bridged), things work correctly?

If that's the case, we should be able to find something in the PPPoE or PPPoA log.  Bridge the modem and configure the UTM interface to authenticate with your ISP.

1. Disable the Interface on the UTM.
2. Start the PPPoE/A live log and wait for it to show some lines.
3. Enable the Interface on the UTM.

Show the log lines for a single connection attempt.

Cheers - Bob

No, i means using the mode setup as router or modem can online . not coonect to UTM in router mode.

Configure UTM Interface as Ethernet with Dynamic IP.  Configure modem in router mode.  Tell/show us what makes you believe that you cannot connect.

Cheers - Bob

I had a problem where the unit I was using would not auto-negotiate the connection speed at hardware level, I set the interface to the max for the device it was connecting to and all started working...

go into Interfaces, Hardware, select the interface, uncheck auto negotiation, then select the highest speed for the interface.

hope this helps

this took me 2 days to work out ( I love standards...lol)

i will try it

try ard , same , down both showing

Sometimes, this is as easy as Jason describes.  Read #7 in Rulz and follow #7.7 to try Jason's suggestion.

Cheers - Bob

have you tried to configure either of the other interfaces, so you can connect with a pc to webadmin?

so, you would have 3 LANs setup (different subnets), and allow access to webadmin via these interface can you get to the webadmin gui on any of the other interfaces?

the other item I came across (when doing initial testing), is when you create the PPPO? interface, if you are using FTTC (VDSL), do you tick the VDSL tick box?

If you do, un-tick the VDSL option and try again.

have you tried to configure either of the other interfaces, so you can connect with a pc to webadmin?

so, you would have 3 LANs setup (different subnets), and allow access to webadmin via these interface can you get to the webadmin gui on any of the other interfaces?

the other item I came across (when doing initial testing), is when you create the PPPO? interface, if you are using FTTC (VDSL), do you tick the VDSL tick box?

If you do, un-tick the VDSL option and try again.