This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

New build : which NICs ?

Hi,

I'm planning a new build that will run UTM or XG. It will either use an i3-6100 or a G4560.

I've found some mainboards that have 2 Intel NICs, like Asrock H270M-ITX/ac. Onboard NICs are Intel I219-V/Intel I211-V. Are they both HW NICs (not SW like realtek ones) ? And are they well supported by UTM/XG ?

Should I rather go with one of these mainboards or buy a dual Intel NICs pci-e card ?

Thanks !

This thread was automatically locked due to age.

0 rfcat_vk over 7 years ago

i219v is not a supported nic. Very disappointing because there are alot of mitx mbs available using that nic.

XG115W - v20.0.2 MR-2 - Home

XG on VM 8 - v21 GA

If a post solves your question please use the 'Verify Answer' button.
Cancel
Vote Up 0 Vote Down

Cancel
0 Alexandre Da Costa over 7 years ago in reply to rfcat_vk

Ah too bad.

Then I will go with an Intel PRO/1000 dual or a Broadcom 5709 dual.

The broadcom has an interesting feature called TCP/IP Offload Engine. Does anyone know if this is supported by UTM or XG ?
Cancel
Vote Up 0 Vote Down

Cancel