HA active-passive state UNLINKED

Question

I've a active-passive HA cluster with two nodes.

Firmware: 9.403-4

Both nodes has the state UNLINKED in the webadmin on the default ETH3 port, but on the ethernet ports and the switchports the LINK LED is on.

Reboot of both nodes doesn't resolve the problem.

What can I do?

Thanks for the help.

nice regards

Christian

This thread was automatically locked due to age.

ChristianSchmidt · Accepted Answer

Hello guys, 
 
 thanks for your Information. 
 
 Last evening I updated the UTM to the lates FW 9.405-5. 
 Than the HA state was the same. 
 Than I rebuild the HA and now it works fine. 
 
 Node 1 is MASTER HA state ACTIVE, node 2 is SLAVE HA state READY. 
 
 Thank you very much guys. 
 
 HAve a nice time. 
 
 nice regards

sachingurung · Answer

Hi Christian, 
 Disable HA and factory reset the passive appliance. Configure it back in HA, it will automatically sync the configuration from the master. Let us know if that helps. 
 Thanks