Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 13 replies
  • Subscribers 8 subscribers
  • Views 14798 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Looking for installation iso-image of version 9.320

MarioKostrzewa

Hello community,

does everyone know a source, where i can become an installaion image of version 9.320?
With three different hardwares i had the same problem, that a newer image like 9.350 could'nt be installed. After the installationcheck, if there is a real utm-appliance, the installation is aborted.
The newest working installationimage i tested was 9.317. Until this version (also with older version like 9.2x) the message appears, that there is no real utm-appliance. But the installation then can be continued instead of aborting.
In my eyes it could be, that an installation of own hardware is possibe with all version before 9.35x. To find this out, i'm looking for the last installation-iso before, the version 9.320.
Thanks in advance

Best regards
Mario



This thread was automatically locked due to age.
  • 0 in reply to MarioKostrzewa

    I don't know what to tell you, Mario.  I have no idea what the problem might be.  This isn't a problem that anyone else is reporting.  I'd probably try with a new hard drive and a new ISO.

    Cheers - Bob

     
    Sophos UTM Community Moderator
    Sophos Certified Architect - UTM
    Sophos Certified Engineer - XG
    Gold Solution Partner since 2005
    MediaSoft, Inc. USA
  • 0 in reply to BAlfson

    Hello Bob,

    thanks for your reply.

    The problem i had with three totally differerent hardwaresystems.
    The only same thing at all three systems was the drive. It is a ssd, samsung evo 850. This ssd i used with all three computers. And every time i formated the drive before i used it for installation.
    Actually i have no possibility to crosscheck the situation with an other drive, like a hdd.

    Thanks to all of communitymembers, which had ideas.

    Best regards
    Mario

  • 0 in reply to MarioKostrzewa

    Mario, have you wiped that hard drive before installing? I'm asking because I just tried to install a software UTM on a drive that had an old UTM220 install on it, and the behavior was similar. It only let me proceed once I deleted all partitions. Maybe they added some additional checks on 9.350 onward to prevent people from installing software UTM on hardware appliances. 

    Just for the sake of making sure your ISO is correct and as a test, setup a VM (virtualbox VM with two network interfaces should do) and try installing using your ISO. 

    Regards - Giovani

Unfiltered HTML