Thread Info
  • Locked Locked
  • Replies 6 replies
  • Subscribers 7 subscribers
  • Views 6214 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Fix UTM build blunder

Tab_Man

How to correct my building b

My build:

Gigabyte B150N-GSM
I3
8 gb ram


My foolish mistake is that I did not pay attention to see that there is no VGA. The motherboard only offers HDMI and the install gets stuck at 66%.

The motherboard also has Dual Gig nics and during install only detects one before getting stuck at %66.

Is there anything I can do to rectify the HDMI, USB vga?



This thread was automatically locked due to age.
Parents

  • Hi and welcome,

    you haven't done anything wrong. The motherboard is not compatible with the UTM installation software. The stop at 66% is caused by the HPT (high performance timer) not being identified by the installing software. The same thing happens on motherboards with the Z170 chipset.

    If you are home user I suggest you try the XG as that MB will work with it.

    XG115W - v20.0.2 MR-2 - Home

    XG on VM 8 - v21 GA

    If a post solves your question please use the 'Verify Answer' button.

  • in reply to rfcat_vk

    I have tried XG as well and the install goes through but it only detects one of the nics.on the motherboard. When it boots it then comes up in failsafe mode. I will continue to research.

    Thanks

Reply Children
Unfiltered HTML