Hardware, Installation, Up2Date, Licensing Fix UTM build blunder

UTM Firewall requires membership for participation - click to join

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Fix UTM build blunder

Tab_Man over 8 years ago

How to correct my building b

My build:

Gigabyte B150N-GSM
I3
8 gb ram

My foolish mistake is that I did not pay attention to see that there is no VGA. The motherboard only offers HDMI and the install gets stuck at 66%.

The motherboard also has Dual Gig nics and during install only detects one before getting stuck at %66.

Is there anything I can do to rectify the HDMI, USB vga?

This thread was automatically locked due to age.

Parents

rfcat_vk over 8 years ago

Hi and welcome,

you haven't done anything wrong. The motherboard is not compatible with the UTM installation software. The stop at 66% is caused by the HPT (high performance timer) not being identified by the installing software. The same thing happens on motherboards with the Z170 chipset.

If you are home user I suggest you try the XG as that MB will work with it.

XG115W - v20.0.2 MR-2 - Home

XG on VM 8 - v21 GA

If a post solves your question please use the 'Verify Answer' button.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

rfcat_vk over 8 years ago

Hi and welcome,

you haven't done anything wrong. The motherboard is not compatible with the UTM installation software. The stop at 66% is caused by the HPT (high performance timer) not being identified by the installing software. The same thing happens on motherboards with the Z170 chipset.

If you are home user I suggest you try the XG as that MB will work with it.

XG115W - v20.0.2 MR-2 - Home

XG on VM 8 - v21 GA

If a post solves your question please use the 'Verify Answer' button.
Cancel
Vote Up 0 Vote Down

Cancel

Children

Tab_Man over 8 years ago in reply to rfcat_vk

I have tried XG as well and the install goes through but it only detects one of the nics.on the motherboard. When it boots it then comes up in failsafe mode. I will continue to research.

Thanks
Cancel
Vote Up 0 Vote Down

Cancel
rfcat_vk over 8 years ago in reply to Tab_Man

Sorry, should have added one of the nics is not supported by either the UTM or XG. i219v

You will need to add another NIC into the expansion slot.

XG115W - v20.0.2 MR-2 - Home

XG on VM 8 - v21 GA

If a post solves your question please use the 'Verify Answer' button.
Cancel
Vote Up 0 Vote Down

Cancel
Tab_Man over 8 years ago in reply to rfcat_vk

The motherboard dual nics are both Intel gig.
Cancel
Vote Up 0 Vote Down

Cancel
rfcat_vk over 8 years ago in reply to Tab_Man

they are different versions. I have one of those boards and that was my findings. Ultimately I disabled both onboard NICs and installed a dual intel in the expansion slot.

XG115W - v20.0.2 MR-2 - Home

XG on VM 8 - v21 GA

If a post solves your question please use the 'Verify Answer' button.
Cancel
Vote Up 0 Vote Down

Cancel