Thread Info
  • Locked Locked
  • Replies 5 replies
  • Subscribers 6 subscribers
  • Views 5562 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

High Availability not working?

Louis-M

We have 2x SG320's in hot standby mode. Each one is plugged into a separate Cisco 2960s switch which is configured correctly for this use.

Failing over doesn't work. We tried again today and the UTM is still syncing some 6 hours later.

Any idea?



This thread was automatically locked due to age.
Parents

  • Iended up rebooting the slave and it finally synced. Not exactly HA if you have to do this. We will be testing within the coming days to ensure that this works as it should.

  • in reply to Louis-M

    I had a similar issue and configuration. I was advised by Support that while HA can work over a switch, the preferred method is via a crossover cable. I put in a crossover cable last night and my issue with HA immediately went away. Are you on 9.4x perchance? It was only after this update that we had issues with HA.

Reply
  • in reply to Louis-M

    I had a similar issue and configuration. I was advised by Support that while HA can work over a switch, the preferred method is via a crossover cable. I put in a crossover cable last night and my issue with HA immediately went away. Are you on 9.4x perchance? It was only after this update that we had issues with HA.

Children
Unfiltered HTML