This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Wireless Bridge to AP LAN Setup Sophos UTM SG 105W

I have been trying to associate my wireless SSID (Bridged to AP LAN) to the local access point. When I select and apply this network, I get the following error message: "The access point "LocalWifi0" can't use the client traffic option :Bridge to AP LAN" which is used by the SSID "xxxx".

Under the interface section: I have a bridge created with the Wifi network and the my LAN port (eth0)

Firewall rule was created to accept communication and also a DHCP server is listed to supply IPs. A masquerade was also set from the Bridge LAN to the wireless.

If someone can help it would be helpful

Thanks

This thread was automatically locked due to age.

Parents

0 TeoCorona over 8 years ago

Correct. I have a built in wifi and need to create the bridge to the LAN.
Cancel
Vote Up 0 Vote Down

Cancel
0 Dlabun over 8 years ago in reply to TeoCorona

I have the 105w as well and every single time I've attempted bridging the wireless the box goes insane in one way or another. It does not appear to be a well supported / documented feature so you may want to try opening a ticket to Sophos.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Dlabun over 8 years ago in reply to TeoCorona

I have the 105w as well and every single time I've attempted bridging the wireless the box goes insane in one way or another. It does not appear to be a well supported / documented feature so you may want to try opening a ticket to Sophos.
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 BAlfson over 8 years ago in reply to Dlabun

Have you guys tried the workaround that I described here? community.sophos.com/.../208698 Cheers - Bob

Sophos UTM Community Moderator
Sophos Certified Architect - UTM
Sophos Certified Engineer - XG
Gold Solution Partner since 2005

MediaSoft, Inc. USA
Cancel
Vote Up 0 Vote Down

Cancel
0 TeoCorona over 8 years ago in reply to BAlfson

I was told that there was a bug on 9.3 and need it to upgrade my firmware. Don't drive yourself crazy, you are probably doing it right.

I'm in the process of doing the firmware update ( not very user friendly), after is done I will update here the results.
Cancel
Vote Up 0 Vote Down

Cancel