This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

UTM 9.3550 1 released

Just had one UTM advise that the software was available for installation.

Up2Date 9.355001 package description:

Remark:
System will be rebooted

News:
Security Update

Bugfix:
Fix [36375]: glibc security update (CVE-2015-7547) [9.35]

RPM packages contained:
glibc-2.11.3-17.95.2.1656.ga688674.rb4.i686.rpm
glibc-locale-2.11.3-17.95.2.1656.ga688674.rb4.i686.rpm
u2d-appctrl43-9-13.i686.rpm
ep-release-9.355-1.noarch.rpm

This thread was automatically locked due to age.

Parents

0 RobertHafner over 8 years ago

Updated and now the flow monitor is broken. I was a few versions behind so this may not be specifically because of this release.
Cancel
Vote Up 0 Vote Down

Cancel
0 BAlfson over 8 years ago in reply to RobertHafner

Robert, what do you mean by "broken?"

Cheers - Bob

Sophos UTM Community Moderator
Sophos Certified Architect - UTM
Sophos Certified Engineer - XG
Gold Solution Partner since 2005

MediaSoft, Inc. USA
Cancel
Vote Up 0 Vote Down

Cancel
0 RobertHafner over 8 years ago in reply to BAlfson

Normally you open it up and it doesn't have data yet, and then it updates with the various services it sees. Since updating all I see is the message saying that it doesn't have data yet, and it never updates that.
Cancel
Vote Up 0 Vote Down

Cancel
0 BAlfson over 8 years ago in reply to RobertHafner

I noticed that, after 30 seconds, there wasn't data in either of two UTMs I tested this on, but when I went back 10 minutes later, both flow monitors were constantly being updated. Does your experience change after a reboot of the UTM?

Cheers - Bob

Sophos UTM Community Moderator
Sophos Certified Architect - UTM
Sophos Certified Engineer - XG
Gold Solution Partner since 2005

MediaSoft, Inc. USA
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 BAlfson over 8 years ago in reply to RobertHafner

I noticed that, after 30 seconds, there wasn't data in either of two UTMs I tested this on, but when I went back 10 minutes later, both flow monitors were constantly being updated. Does your experience change after a reboot of the UTM?

Cheers - Bob

Sophos UTM Community Moderator
Sophos Certified Architect - UTM
Sophos Certified Engineer - XG
Gold Solution Partner since 2005

MediaSoft, Inc. USA
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data