This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Sophos AP100 and 5GHz mesh

Hello all,

i just got 2 Sophos AP100 and was hoping that I could use them to set up a 5GHz mesh, according to the Mesh compatibility list they should be compatible in Sophos UTM for 5GHz mesh.

Firmware Version is 9.712-13

However, I cannot create a 5GHz mesh an add one of them to it, I always get the error message "Does not support mesh in this band".

I can add them both to a 2.4GHz without a problem. I tried deleting the mesh, recreating it, no success with 5GHz.

Is there anything more I have to do to get the AP100 to a 5GHz mesh?

Thanks,

Olaf



This thread was automatically locked due to age.