This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Sophos AP100 and 5GHz mesh

Hello all,

i just got 2 Sophos AP100 and was hoping that I could use them to set up a 5GHz mesh, according to the Mesh compatibility list they should be compatible in Sophos UTM for 5GHz mesh.

Firmware Version is 9.712-13

However, I cannot create a 5GHz mesh an add one of them to it, I always get the error message "Does not support mesh in this band".

I can add them both to a 2.4GHz without a problem. I tried deleting the mesh, recreating it, no success with 5GHz.

Is there anything more I have to do to get the AP100 to a 5GHz mesh?

Thanks,

Olaf

This thread was automatically locked due to age.

Parents

0 rfcat_vk over 2 years ago

Him

assumption you are only trying to mesh in one band not both at the same time?

Ian

XG115W - v20.0.2 MR-2 - Home

XG on VM 8 - v21 GA

If a post solves your question please use the 'Verify Answer' button.
Cancel
Vote Up 0 Vote Down

Cancel
0 OlafL over 2 years ago in reply to rfcat_vk

Yes sure, just trying to set up one single mesh with only the 2 AP100. Trying to set it up as a 5GHz mesh - no, deleting it and set up an new 2,4GHz mesh - yes.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 OlafL over 2 years ago in reply to rfcat_vk

Yes sure, just trying to set up one single mesh with only the 2 AP100. Trying to set it up as a 5GHz mesh - no, deleting it and set up an new 2,4GHz mesh - yes.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data