This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

No interface found on Nexcom DNA120

Hello everyone. I just bought a Nexcom DNA120 (I understand that it is hardware similar to the UTM SG115) and I am trying to install version 18.5.3.
At the end of the installation, it enters failsafe mode, and tells me that it does not detect network interfaces.
From what I see it has Intel I211AT adapters, which I see are compatible with Sophos XG.
If I install windows on the box, the interfaces work correctly.
Is it necessary to make any additional settings with these network adapters? Thank you very much!


This thread was automatically locked due to age.
  • You may want to ask on the XG forums, as it looks like that is an XG version, not a UTM one.  

    However, if you have UEFI enabled, you will need to have that disabled in the BIOS.  But, I would try on XG forums, someone there might be able to help out better.

    OPNSense 64-bit | Intel Xeon 4-core v3 1225 3.20Ghz
    16GB Memory | 500GB SSD HDD | ATT Fiber 1GB
    (Former Sophos UTM Veteran, Former XG Rookie)