Hi.
I got my selfe a APX 320, and i far as i know its unused.i connected it to the network and waiting for it to apper Pending Access Points but it dont.
DHCP has relesed a IP to the AP, and still noting.Have already have aAP50 working, but the APX320 is a no-show...
i seen in the forum that was/is a FW problem and the tcp port is not correct in the firmware.
Is there a way to fix this?
/Dan Ove
even if it was said in the forum it doesn't work ... I would try to build a DNAT rule and only change the DST port from 2713 to 2712. Check beforehand with TCPDump which target is being addressed (I think IP: 1.2.3.4)
... and wait a long time...
If it is a paid licence, open an RMA.
Dirk
Sophos Solution Partner since 2003 If a post solves your question click the 'Verify Answer' link.