This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Disable HA/shutdown slave making bringing LAG down on master

Hi Team,

I have 2 Sophos UTM 330 in live master slave mode.When ever I disable HA / or shutting slave my routing table is getting vanished. I mean the lag stop working. I then toggle interfaces. it is becoming normal again. May I know why it is happening. I observed this scenario in many cases across DCs

Regards

Sai Bhargav

This thread was automatically locked due to age.

0 dirkkotte over 5 years ago

Do you build one LAG per device?

If you use 2 ports from master, this should be one LAG and the two ports from the slave should be a different LAG group.

I got problems connecting Master and Slave into same LAG.

Dirk

Systema Gesellschaft für angewandte Datentechnik mbH // Sophos Platinum Partner
Sophos Solution Partner since 2003
If a post solves your question, click the 'Verify Answer' link at this post.
Cancel
Vote Up 0 Vote Down

Cancel
0 Sai Bhargav over 5 years ago in reply to dirkkotte

hi Yes, one lag per device.It has two interfaces eth10,11. We tagged two vlans . One for internal and one for external. I see interfaces were green in GUI but their IPs are not shown on ifconfig. I disabled and enabled both interfaces on GUI. Slowly routing started building

Regards

Sai Bhargav
Cancel
Vote Up 0 Vote Down

Cancel
0 BAlfson over 5 years ago in reply to Sai Bhargav

Hi Sai,

Please compare your topology to this diagram.

Cheers - Bob

Sophos UTM Community Moderator
Sophos Certified Architect - UTM
Sophos Certified Engineer - XG
Gold Solution Partner since 2005

MediaSoft, Inc. USA
Cancel
Vote Up 0 Vote Down

Cancel