This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

UTM 9 updates

I need a Help, i have two SOPHOS UTM 9, that are running with firmware version 9.710-1 and connected via IP sec tunnel, i want to start a update on two firewalls but i have a worries if i lose a connection between firewalls because one of them is far from me, so please what is the best steps to do before staring updates. thank you



This thread was automatically locked due to age.
Parents
  • Hi Mustapha,

    I have a similar configuration which I've updated many times without issues. I am confident that my configuration is good and that it all comes up cleanly after a reboot. I would advise testing this if you're not confident in your config.

    Step 1: upload the new firmware to both firewalls.

    Step 2: SCHEDULE (rather than immediately installing) the update on both firewalls.

    I normally schedule my updates to take place overnight & at the same time on both firewalls. The IPsec tunnel is down only during the reboot.

    --Larry

Reply
  • Hi Mustapha,

    I have a similar configuration which I've updated many times without issues. I am confident that my configuration is good and that it all comes up cleanly after a reboot. I would advise testing this if you're not confident in your config.

    Step 1: upload the new firmware to both firewalls.

    Step 2: SCHEDULE (rather than immediately installing) the update on both firewalls.

    I normally schedule my updates to take place overnight & at the same time on both firewalls. The IPsec tunnel is down only during the reboot.

    --Larry

Children