2nd WAN - no failover or load balancing

Hi,

Thanks for reaching out to Sophos Community and hope you are well. 

Seems UTM Multipath rules configuration would achieve your use case: https://support.sophos.com/support/s/article/KB-000034635?language=en_US

Hope this helps and thank you for choosing Sophos

Regards,

Thank you.  Can you be more specific?  I looked at that extensively and was not able to create a working configuration.  I am not interested in load balancing or failover - does your recommendation still apply?  Thanks again.

We can use, Itf. Persistence: Interface persistence is a technique which ensures that subsequent connections from a client are always routed over the same uplink interface.

Then we under it we can use: By Interface: Select an interface from the Bind Interface drop-down list. All traffic applying to the rule will be routed over this interface.

and this would achieve the use case above for your future state. 

Future State:

• LAN = 192.168.0.x/24 -> WAN - ISP 1
• DEVICE1 = 192.168.0.130 -> WAN2 - ISP 2

Regards,

We can use, Itf. Persistence: Interface persistence is a technique which ensures that subsequent connections from a client are always routed over the same uplink interface.

Then we under it we can use: By Interface: Select an interface from the Bind Interface drop-down list. All traffic applying to the rule will be routed over this interface.

and this would achieve the use case above for your future state. 

Future State:

• LAN = 192.168.0.x/24 -> WAN - ISP 1
• DEVICE1 = 192.168.0.130 -> WAN2 - ISP 2

Regards,