Dual ISPs configured in load balancing, SSL VPN and user portal goes down.

Hi Dave and welcome to the UTM Community!

Load Balancing and Uplink Balancing are two different things.  The problem you're describing sounds more like a problem with something in front of the UTM and not a configuration in the UTM.  If you think it's in the UTM, please insert a picture of the Edit of the setting.

Cheers - Bob

 I am unsure which settings you want picts. of but I have included a few. The reason I think it is a Sophos setting is because if I use the IP address of the second ISP instead of the domain name I can access both VPN and the user portal. It seems that somehow they are tied to the primary ISP address. 

Uplink Balancing only affects outbound requests, Dave, not outbound responses nor inbound requests.

I'm confused.  Do you have a router in front of the UTM that's doing load balancing?  If it's switching primary between the two ISPs, how does it update DNS?

Cheers - Bob

Sorry I haven't been more clear. We do not having anything in front our Sophos UTMs. Traffic goes thru them first right after the modems from our providers and then onto the router . The reason I think something is happening in the Sophos is because the Cox IP becomes unreachable for the VPN and I can use the Windstream IP to reach the VPN if I put it in manually and then later it switches and becomes reachable again. Any insights you have will be appreciated.

Thanks,

Dave

What is the purpose of the round-robin in your DNS server, Dave?

Cheers - Bob

In trying to troubleshoot I thought that the new IP could point to the domain name of the Sophos but it did not help.

OK, to explain it a little more clear here is our setup. We have 2 ISPs coming into our Sophos UTM firewalls set to uplink balancing.

We have a GoDaddy domain server with both static IPs of the ISPs pointing to the portal domain name of the Sophos. When uplink balancing is enabled with both ISPs the VPN will become unreachable.With uplink balancing not enabled with the Cox as the connection everything works as normal. We are using the Sophos SSL VPN for our remote access.

What do you have in the 'Interface address' box on the 'Settings' tab, Dave?  Insert a picture of the Edit of any relevant Multipath rule.

Cheers - Bob

In the interface IPv4 address we have the static IP given by the ISP. In the IPv4 Netmask we have what was given by the ISP. We have IPv4 Default GW checked and the gateway address in the gateway field. The multipath rules are currently not active because they did not make any difference, but they are attached. I created number 1 which was to bind both user portal and SSL users to are Cox line. The second was made by our MSP to bind the user portal to Cox. We did not have both active at the same time.

As bob say already ... "Uplink Balancing only affects outbound requests ... not outbound responses nor inbound requests"
So your multipath configuration is not interesting.
Please post your interface-configuration.
Which interface do you allow within Portal & SSL-VPN configuration?

Steps for troubleshooting are (based on the osi layer model) ...
1st:  Is the interface reachable ... try to ping/telnet the both interfaces from external (enable ping reachability temporary)
2ng: try to connect SSl-VPN ... configure only one destination IP (not DNS) within the corresponding OVPN-file at the client.