This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Uplink / Multipath

Hallo,

my uplink failover didn't work. One DSL Channel (WAN.COLT) had a download rate of 0.1 Mbit/s (instead of 1 Gbit/s). There should be a failover to WAN.QSC but it wasn't activated so I pulled the DSL Cable off the Router. Can you please correct my Configuration?

I changed from

WAN.COLT 100 / WAN.QSC 0

WAN.COLT 50 / WAN.QSC 50

(WAN.COLT error is because I pulled the DSL cable. Since it was plugged in I had ping timeouts, in about every 5th ping. Since I unplugged the cable it was stable)

This thread was automatically locked due to age.

Top Replies

dirkkotte over 3 years ago +2 suggested

Failover is for lost connection ... not for bad connection ... unfortunately. Your configuration looks ok. Possible i would shorten the "persistence timeout"

Parents

0 dirkkotte over 3 years ago

Failover is for lost connection ... not for bad connection ... unfortunately.
Your configuration looks ok.
Possible i would shorten the "persistence timeout"

Dirk

Systema Gesellschaft für angewandte Datentechnik mbH // Sophos Platinum Partner
Sophos Solution Partner since 2003
If a post solves your question, click the 'Verify Answer' link at this post.
Cancel
Vote Up +2 Vote Down

Cancel
0 Martin Seidel over 3 years ago in reply to dirkkotte

Thanks!
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Martin Seidel over 3 years ago in reply to dirkkotte

Thanks!
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data