due to a SFP change at one of our clusternode I was trying to use the
ha_daemon -c takeover
to change the active node. After hitting <enter> nothing happened and the node kept being the active node.
Cluster is a SG230 running firmware 9.705-3
Do I miss something? Do I need to use an other command? Pretty new into Sophos... Tried this command on a SG210-Cluster which was working as expected.
And I don´t want to shut off the node where I need to change the SFP.
Hi Marc P1,
Adding "-" or "-l" has two effects; read more about them at the following link:
The command works, I confirmed in my LAB with or…
Thanks for reaching out to the Community!
Did you try to run the command as a root user? If not, try to switch to the root user with "su -" and run the command.
However, to install/change/update the SFP module, you would have to power down both nodes and install the new hardware.
The next step would be to power up the primary and then secondary unit and then run the following command from the backend:
This will reset the interface objects, and then the Flexiport module should be visible on the GUI.
Community Support Engineer | Sophos Technical SupportSupport Videos | Product Documentation | @SophosSupport | Sign up for SMS Alerts If a post solves your question use the 'Verify Answer' button.
yes I am connected as the root user.
But logged in as loginuser and then only used "su" without a "-", can´t believe this makes any difference?
I mean, I want to swap a single SFP not the whole SFP module. And maybe it is fine to do it without a failover, but I would like to use the command and be safe there will be no problem by disconnecting the current SFP.
The command works, I confirmed in my LAB with or without "-"
Could you please double-check the HA status from Management > High Availability > Status? Is it Active/Ready?.
However, I would schedule a proper maintenance window to make any hardware changes to avoid any service outage during production hours.
ok, many thanks for verifing!
I´ll test the command on friday again and will write the result here again. If it is not working I´ll need to do a real maintanance.