This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

How to connect Sophos SG125 for HA (active-passive)

Hello, we have 2x Sophos SG125. Node 1 and Node 2. I would like to have HA (active and passive) but I dont know how to connect it right with ethernet cables. The only thing what I connect is from HA (Node 1) to eth7 (Node2).Can you help how I should connect ethernet cables? Node 2 should be the master. Thank you.

This thread was automatically locked due to age.

Top Replies

FormerMember over 3 years ago +2 verified

Hi Jiri Skryja , Thank you for reaching out to Sophos Community. You can set up the cable connection by referring to the below diagram. Please refer support.sophos.com/.../KB-000038677 article…

Parents

+1 FormerMember over 3 years ago

Hi Jiri Skryja,

Thank you for reaching out to Sophos Community.

You can set up the cable connection by referring to the below diagram.

Please refer support.sophos.com/.../KB-000038677 article to configure High Availability in Hot-Standby (Active-Passive).
Cancel
Vote Up +2 Vote Down

Cancel
0 Jiri Skryja over 3 years ago in reply to FormerMember

Hello, thank you for your answer. So I will connect it from HA (Node1) to HA (Node2) and reconfigure it. Thank you for help.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Jiri Skryja over 3 years ago in reply to FormerMember

Hello, thank you for your answer. So I will connect it from HA (Node1) to HA (Node2) and reconfigure it. Thank you for help.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data