Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 2 replies
  • Subscribers 5 subscribers
  • Views 972 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Sophos SG450 Cluster Node destroyed after installing Update 9.703-3

Bepo

Hello Community,

we have an SG450 Cluster with Sophos UTM Firmware Version:  9.602 

Due to RAID DEGRADATION of one node we opened a RMA case and Sophos sent a new SG450 Node.

On this Node was UTM Firmware: 9.702 installed.

Yesterday we wanted to upgrade the SG450 cluster from UTM Firmware version: 9.602 to Firmware version: 9.703-3 via UP2DATE.

After starting the update one the SLAVE node (the node without raid degradation) and restart of this node (automatically from up2date),

the display shows: ERROR STATUS. The filesystem of this node was completly destroyed. No boot possible. --> FAIL SAFE image of Sophos was booted. 


Fortunately we had an prepared SOPHOS SUSI Stick. (Sophos - Flash (Firmware) - UTM Smart Installer - 4GB)

With this we could reinstall the damaged node and then built up the Active-Passive-HA again.


Does anyone had also problems with 9.703?

 

 

Thanks so far!

 

 

 



This thread was automatically locked due to age.
Unfiltered HTML