This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Bridged Mode Modem

ISP just set up my modem into bridge mode, but after I connected my SG135 , the computers connected to the SG135 does not have internet. Dashboard shows the green UP on the internet but the no internet on computers. I think there is something wrong in configuration on my Interfaces but I can't find the mistake. I would really appreciate the help. Thanks

This thread was automatically locked due to age.

Parents

0 Argo over 5 years ago

Hi KhaLev,

please provide more details like screen shot of your current interface setup, the IP Address it is getting etc.

XG & UTM Architect (Systems: XG v18 & UTM 9.7 - Virtual, HW & SW)
Curious enough to take it apart, skilled enough to put it back together, Clever enough to hide the extra parts when I'm Done!
Cancel
Vote Up 0 Vote Down

Cancel
0 KhaLev over 5 years ago in reply to Argo
Cancel
Vote Up 0 Vote Down

Cancel
0 Argo over 5 years ago in reply to KhaLev

I am unable to see anything on the image can you clear it up for me?

XG & UTM Architect (Systems: XG v18 & UTM 9.7 - Virtual, HW & SW)
Curious enough to take it apart, skilled enough to put it back together, Clever enough to hide the extra parts when I'm Done!
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Argo over 5 years ago in reply to KhaLev

I am unable to see anything on the image can you clear it up for me?

XG & UTM Architect (Systems: XG v18 & UTM 9.7 - Virtual, HW & SW)
Curious enough to take it apart, skilled enough to put it back together, Clever enough to hide the extra parts when I'm Done!
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 KhaLev over 5 years ago in reply to Argo
Cancel
Vote Up 0 Vote Down

Cancel
0 KhaLev over 5 years ago in reply to Argo

The modem's Public IP Address is 124.107.75.241
Cancel
Vote Up 0 Vote Down

Cancel
0 Argo over 5 years ago in reply to KhaLev

Hi KhaLev,

I believe you are using the incorrect l type of connection.

the type most use is PPPoE, then you enter the account that the ISP provided (usually username@provider) don't forget the password.

you can also enter the static IP for a PPPoE connection if required.

have you tried this?

XG & UTM Architect (Systems: XG v18 & UTM 9.7 - Virtual, HW & SW)
Curious enough to take it apart, skilled enough to put it back together, Clever enough to hide the extra parts when I'm Done!
Cancel
Vote Up 0 Vote Down

Cancel
0 Jay Jay over 5 years ago in reply to KhaLev

What do you get when you connect a pc/laptop directly to the modem? Do you get a public ip and have connectivity? If so, I'd set up the interface as dynamic ipv4.
Cancel
Vote Up 0 Vote Down

Cancel
0 BAlfson over 5 years ago in reply to KhaLev

Not sure what you're doing to capture images, but they are too small to be legible.

Cheers - Bob

Sophos UTM Community Moderator
Sophos Certified Architect - UTM
Sophos Certified Engineer - XG
Gold Solution Partner since 2005

MediaSoft, Inc. USA
Cancel
Vote Up 0 Vote Down

Cancel