[CONFIRMED] [7.360] Upgrade not working ?

Hi

think I went too quickly for upgrade [:(] after things seems to be frozen for 2 minutes I did a reboot with an ASG 120... now I still at 7.350 and no more upgrade to 7.360..

I was stuck onto the attached snapshot...

I forgot what to do to reset upgrade stuff ?

thx
Parents Reply
  • It's part of the 7.350, otherwise you wouldn't be able to see it when doing the up2date (old installer needed to update the installer [:P]).

    About the "Running syncing step 1" in the post-stop phase:
    The installer only knows that a phase was completed if a command in a higher phase is executed. So if there is nothing to do in a phase, it will not be marked as completed until another operation in the next phase has been done. If there are multiple phases where nothing is left to be done, it looks like the progress you did see. With the current coloring scheme, it is not possible to see which phase is currently active, because it looks grey like all phases that were not started yet.

    The reason why there was nothing to be done, not even in the install phase, is that the installer became smarter. Previously, if the up2date installation failed in between like it did for you with the openvpn package, you would have had to do the old "--rpmargs --force" on the commandline. With the new installer, you can just re-run the installation from the webadmin. The installer will detect any RPMs that have already been installed successfully, and not try to re-install them (and therefore probably shortening the installation phase considerably). 

    Cheers,
     andreas
Children
No Data