Sophos UTM: Decommissioning of obsolete URL categorization services CFFS.Click here for important info.

BUG v19.5 EAP hardware monitoring - XG115W LAN interface died

Hi folks,

last night one of the LAN interfaces on my XG115W died, just stopped, this interface is used for video streaming and IoT devices. The following steps were tried to restart it

1/. edit the interface, failed to restart

2/. restarted the XG, interface failed restart

3/. powered off and removed the power connection, interface failed to restart after power up.

Frustrated, started planning on restoring my home licence box to production,  a lot of work required.

Suddenly, 30 minutes after the last restart the interface became live and started passing traffic.

There is a bug in the V19.5 EAP hardware management software, the log viewer -> system showed the interface as up even though it was down. At this stage the XG was using about 90% ram and CPU was over 70%.


Parents Reply
  • Hi bobbylam,

    Why did I suspect someone was in the XG, shortly after restoring service I investigated the logs and found numerous SSH successful and failed connections around the failure time.

    I suspect the failure is caused by the unit overheating because it was very warm when I restarted it compared to now.

    The unit would pass some traffic, I could not connect to the GUI and a number of devices could not refresh their IP address.

    The restart was achieved by using the power switch at the rear of their unit. The restart took about 10 minutes and not all interfaces started passing traffic immediately.

    The unit sits on a shelf in an open book case.


    XG115W - v19.5.3 mr-3 - Home

    If a post solves your question please use the 'Verify Answer' button.

No Data