Important note about SSL VPN compatibility for 20.0 MR1 with EoL SFOS versions and UTM9 OS. Learn more in the release notes.

Thread Info
  • State Suggested Answer
  • Locked Locked
  • Replies 2 replies
  • Answers 1 answer
  • Subscribers 40 subscribers
  • Views 7163 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Can't find system disk during XG Firewall install on cciss array

ChrisClemons

I currently have Sophos UTM 9 running on an HP DL380 G2. The RAID controller is an HP SmartArray that uses the cciss kernel module/driver. It runs perfectly fine and the installer during the hardware detection phase recognizes the cciss array.

However when trying to boot the Sophos XG install ISO I get an error that it can not find the system disk. There is no troubleshooting options. No way to drop to a terminal. The only option is "Press Y to reboot".

I'm using the "Firewall OS Software ISO for Intel Hardware" from this page to attempt the install. One parculiar thing I noticed is that the ISO is MUCH smaller than the Sophos UTM 9 install ISO. The ISO I'm getting for XG is 289MB while the UTM ISO I have is 790MB.

Am I doing something wrong or is there no support for cciss RAID devices in XG Firewall?



This thread was automatically locked due to age.
Parents Reply Children
Unfiltered HTML