Hi all,
i am unable to find the point within GUI, where I can configure the IP / DNS used by Sophos-Connect IPSec to terminate the connection.
Any hints?
Many thanks, Dirk
This thread was automatically locked due to age.
Thanks,
but the IP/DNS information after Tunnel is established isn't my problem/question.
I search the point where i have to set the external XG-Firewall-IP or name the client should use to connect VPN to the XG.
Dirk
Systema Gesellschaft für angewandte Datentechnik mbH // Sophos Platinum Partner
Sophos Solution Partner since 2003
If a post solves your question, click the 'Verify Answer' link at this post.
Hello Dirk,
That option in the GUI is only available for the SSL VPN client to set the IP or FQDN.
For Sophos Connect, if you want to set an FQDN you need to use the Provisioning File.
Regards,
Thanks, change the settings within configuration file(.scx/.tgb) ... using Admin tool or not.... is known ... but ...
At my Home Appliance, i have the external FQDN within the fresh downloaded config-file. Possible this configuration was able with an older version...?
Dirk
Systema Gesellschaft für angewandte Datentechnik mbH // Sophos Platinum Partner
Sophos Solution Partner since 2003
If a post solves your question, click the 'Verify Answer' link at this post.
No, i mean the old version of SFOS. The GUI option must have existed in the past.
... because my external dyndns-name it is configured within my downloaded config-files.
Dirk
Systema Gesellschaft für angewandte Datentechnik mbH // Sophos Platinum Partner
Sophos Solution Partner since 2003
If a post solves your question, click the 'Verify Answer' link at this post.