RAS-IPSec - where to configure the connection target

Hi dirkkotte,

Thank you for reaching out to Sophos Community.

IP & DNS information for Sophos Connect can be configured from CONFIGURE > IPsec (remote access) > Client information.

Thanks,
but the IP/DNS information after Tunnel is established isn't my problem/question.
I search the point where i have to set the external XG-Firewall-IP or name the client should use to connect VPN to the XG.

Hello Dirk,

That option in the GUI is only available for the SSL VPN client to set the IP or FQDN.

For Sophos Connect, if you want to set an FQDN you need to use the Provisioning File.

Regards,

Hi dirkkotte,

Just adding to what Emmanuel has said,

You can also modify the configuration file(.scx/.tgb) using Sophos Connect Admin and change 'Target host' with the required hostname or IP address.

Thanks, change the settings within configuration file(.scx/.tgb)  ... using Admin tool or not.... is known ... but ...

At my Home Appliance, i have the external FQDN within the fresh downloaded config-file. Possible this configuration was able with an older version...?

Thanks, change the settings within configuration file(.scx/.tgb)  ... using Admin tool or not.... is known ... but ...

At my Home Appliance, i have the external FQDN within the fresh downloaded config-file. Possible this configuration was able with an older version...?

dirkkotte said:

Possible this configuration was able with an older version...?

Are you referring to the older version of the Sophos Connect client?

No, i mean the old version of SFOS. The GUI option must have existed in the past.
... because my external dyndns-name it is configured within my downloaded config-files.