Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 2 replies
  • Subscribers 0 subscribers
  • Views 12635 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Web Appliance Gateway VS Checkpoint

simquest

In the Sophos web gateway documentation, he say: In your router/firewall Redirect http trafic to the transparent gateway.

I'm trying to redirect the traffic in checkpoint to the Sophos Gateway.  I don't know the procedure.

Is it with URI, CVP ???

Thanks you.

:37495


This thread was automatically locked due to age.
Parents
  • 0

    Hello simquest,

    What version of FW-1 are you using?

    The following article at Checkpoint support site, SK40348, talks about setting up an HTTP redirection for a URI resource.

    I'm less fond of this, however have you looked into WCCP? This is where you would write a redirection ACL on the switch that captures traffic on port 80, 443, 21 etc, and then sends it to some other device on your network.

    Erric

    :37591
Reply
  • 0

    Hello simquest,

    What version of FW-1 are you using?

    The following article at Checkpoint support site, SK40348, talks about setting up an HTTP redirection for a URI resource.

    I'm less fond of this, however have you looked into WCCP? This is where you would write a redirection ACL on the switch that captures traffic on port 80, 443, 21 etc, and then sends it to some other device on your network.

    Erric

    :37591
Children
No Data
Unfiltered HTML