Hi all,
I have a most probably stupid question, but I must ask it, because I don't fully understand the configuration of the Sophos AP30. Here is the case:
I have a Sophos SG 125 with its management interface connected over port eth0 to our internal company network - 192.168.1.0/24. When I connect the AP to the same Switch to which the SG Mgmt interface is connected, the AP gets an IP from the DHCP in the same scope, but my AP does not appear in the "Pending Access Points" on the SG 125. I can still ping the AP over the Network.
But if I plug the AP30 directly on one of the ports of the SG 125, for example port eth3, configure the Interface in another subnet - 192.168.2.0 and enable DHCP, I am able to see the device under "Pending Access Points" and then authorize it.
So I am doing something wrong or the AP cannot be connected to the SG over the same LAN, in which the SG has its management interface?
Many thanks in advance for your help and answers!
This thread was automatically locked due to age.
