This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

UTM 110 and AP10 setup

Hello,

Just got a new UTM 110 and AP10 for a client. Could someone suggest the best way to connect the AP10, so it can utilize the web protection on the UTM?

- #1 Connect to one of the Interface on the UTM ether2 or
- #2 Connect to a Netgear switch

I tried #2 and let it auto configure with wlan0, but web security is not filtering client connect to the AP10

Thanks for any suggestion

This thread was automatically locked due to age.

Parents

0 apijnappels over 10 years ago

If you don't bridge the WLAN (like in a guest wifi), you need to add this network interface to the web filtering allowed networks list.

Managing several Sophos firewalls both at work and at some home locations, dedicated to continuously improve IT-security and feeling well helping others with their IT-security challenges.
Cancel
Vote Up 0 Vote Down

Cancel
0 dknyinva over 10 years ago in reply to apijnappels

Thank you both for your reply. I went with both your suggestions and connect the AP10 to the netgear and setup an SSID and set client traffic to bridge to the AP LAN and it works. Just another question

It said that the AP10 can have up to 8 SSIDs. Can I created another SSID for guest with no encryption and set client traffic to separate zone? I tried it and couldn't get an IP address.

Thanks again
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 dknyinva over 10 years ago in reply to apijnappels

Thank you both for your reply. I went with both your suggestions and connect the AP10 to the netgear and setup an SSID and set client traffic to bridge to the AP LAN and it works. Just another question

It said that the AP10 can have up to 8 SSIDs. Can I created another SSID for guest with no encryption and set client traffic to separate zone? I tried it and couldn't get an IP address.

Thanks again
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data