This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

AP30 - UTM9 - Wireless Broadcast

I have a UTM9 appliance, i have the static route of 1.2.3.4 255.255.255.255 10.1.1.1 (Gateway appliance IP) configured in my router.
I can ping the AP
I can trace 1.2.3.4 which arrives at the gateway appliance, however the Access Point never registers with the appliance.

This thread was automatically locked due to age.

Parents

0 treskaan over 11 years ago

Hi,
did you add the interface to the allowed wireless interfaces??
Greetings Andreas
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 treskaan over 11 years ago

Hi,
did you add the interface to the allowed wireless interfaces??
Greetings Andreas
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 paul.hurst@airdrie.ca over 11 years ago in reply to treskaan

Two possible interfaces include
Bridge 10.1.1.1
Active Directory Management 10.2.1.1

Right now the route reads

ip route 1.2.3.4 255.255.255.255 10.1.1.1
Cancel
Vote Up 0 Vote Down

Cancel
0 paul.hurst@airdrie.ca over 11 years ago in reply to paul.hurst@airdrie.ca

Ok i got sick of trying to route 1.2.3.4 (dumbass idea to use this) and connected my virtual appliance to the VLAN that the AP's will be connected to. And look at that i can actually start configuring the AP.

The issue now appears RADIUS authentication and configuring the network ports on the switch correctly. Previous AP's i can do trunking but looks like these do not like trunk mode.
Cancel
Vote Up 0 Vote Down

Cancel