This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Need help, how to setup 3 AP50

I have 3AP50 1AP30. I also have two different network (Internal and Guest).

Before I have two cisco AP, I use trunk to setup VLANs.

How can I setup 3 AP50 with two SSIDs each.

Thanks,

This thread was automatically locked due to age.

Parents

0 BarryG over 11 years ago

Hi, you can do "bridge to interface" for each SSID (using a LAN or VLAN), or you can create new, independent, networks for each (non-bridged mode).

see also
https://community.sophos.com/products/unified-threat-management/astaroorg/f/60/t/56383

Barry
Cancel
Vote Up 0 Vote Down

Cancel
0 fsyong over 11 years ago in reply to BarryG

Thanks for your help.

My question is: first you need to assign a network in global settings to activate the AP. In this case how can you assign VLANs.

Hi, you can do "bridge to interface" for each SSID (using a LAN or VLAN), or you can create new, independent, networks for each (non-bridged mode).

see also
http://www.astaro.org/other-products/wireless-security/48342-new-wireless-security.html#post239223

Barry
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 fsyong over 11 years ago in reply to BarryG

Thanks for your help.

My question is: first you need to assign a network in global settings to activate the AP. In this case how can you assign VLANs.

Hi, you can do "bridge to interface" for each SSID (using a LAN or VLAN), or you can create new, independent, networks for each (non-bridged mode).

see also
http://www.astaro.org/other-products/wireless-security/48342-new-wireless-security.html#post239223

Barry
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data