This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

re-run auto configuration wizard AP50

How To Re-run Auto Configuration Wizard AP50
I connected a new AP50. It connected to UTM and ran a wizard by itself. Now I want to run it again, how do I force the wizard to run? I executed the re-flash and let it it re-connect. Now the AP50 is sitting in my pending access points section.
UTM ver 9.004-34
Patrick

autoconfiguration
auto-configuration
AP-50
AP 50

This thread was automatically locked due to age.

Parents

0 treskaan over 11 years ago

Hi,
the wizard only runs once. You have to setup your other networks manually. You can vote for the wireless wizard in our feature forum, this covers your request.
Greetings,
Andreas
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 treskaan over 11 years ago

Hi,
the wizard only runs once. You have to setup your other networks manually. You can vote for the wireless wizard in our feature forum, this covers your request.
Greetings,
Andreas
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data