This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

AP10 AP30 AP50 no 40mhz support

Hey,

why this Accespoints dont't support the 40mhz to get the full speed.
All other solutions support this.

In the datesheet are written for the products.
150 / 300 / 300

Is it possible to use it in the future? Workaround?

greets

McM

This thread was automatically locked due to age.

Parents

0 trollvottel over 10 years ago

Check this out: https://community.sophos.com/products/unified-threat-management/astaroorg/f/60/t/56512
Cancel
Vote Up 0 Vote Down

Cancel
0 rfcat_vk over 10 years ago in reply to trollvottel

Hi,
I implemented the 40mhz channel change for the Beta UTM (9.280) and cannot find a device around here that will do 40mhz on an AP10.
I put the analyser on and it only shows channel 1 for the AP10.

I have restarted the UTM and am wondering what I can do to check if the setting stuck?

If I could find the up2date package for the migration from beta to GA I would try the 40mhz on the AP50. I have the up2date for 9.301, just need 9.300GA.

Ian

XG115W - v20.0.2 MR-2 - Home

XG on VM 8 - v21 GA

If a post solves your question please use the 'Verify Answer' button.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 rfcat_vk over 10 years ago in reply to trollvottel

Hi,
I implemented the 40mhz channel change for the Beta UTM (9.280) and cannot find a device around here that will do 40mhz on an AP10.
I put the analyser on and it only shows channel 1 for the AP10.

I have restarted the UTM and am wondering what I can do to check if the setting stuck?

If I could find the up2date package for the migration from beta to GA I would try the 40mhz on the AP50. I have the up2date for 9.301, just need 9.300GA.

Ian

XG115W - v20.0.2 MR-2 - Home

XG on VM 8 - v21 GA

If a post solves your question please use the 'Verify Answer' button.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data