This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

AP50 does not connect to ASG

My new AP50 does not connected to my ASG 220.
I created the following test position:

ASG220

eth0: 192.168.0.1
eth1: IP from my ISP and default gw from ISP
eth4: 192.168.50.1

DHCP activated on eth4

Wirless Security default installation and approved networks is eth4.

eth4: ASG 220 Switch AP50

This thread was automatically locked due to age.

Parents

0 peterkieser over 12 years ago

Did you select "Bridge to AP LAN" or separate "Client Zone" for the Wireless Networks? If you created separate Client Zone then you will need to add a DHCP Server for the interface.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 peterkieser over 12 years ago

Did you select "Bridge to AP LAN" or separate "Client Zone" for the Wireless Networks? If you created separate Client Zone then you will need to add a DHCP Server for the interface.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data