Hello!
I have some problems with my 2 access points.
They are both shown as inactive all time, even if both ssids are working.
I actualle browsing web through one of the ssid right now.
I have a suspicies though of it can be the vlan settings.
I use 3 vlans. Vlan 5,6 and 10. 5 is guest network, 6 is management, and 10 is home network.
How to configure the switch to allow access to both vlan 5 and 10, when the APs are allowed to connect in vlan 6? Both allowed networks is vlan 6, and under advanced button the "AP VLAN ID" is set to 6.
Earlier i tried to set up a trunk with vlan 6 tagged, vlan5 and 10. But the AP never showed up. Then i tryed with vlan 1(native) tagged, and the others untagged. Then the AP showed up, but was unstable. But when i added vlan 1 to allowed networks, then it works, but the AP in inactive.
Is running PoE powered AP30, with Cisco SG 200-26G switch and ASG 8.202.
Why?
This thread was automatically locked due to age.
