Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 14 replies
  • Subscribers 1 subscriber
  • Views 6076 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

AP-30 not working in vlan configuration

dhyanesh.mehta
Hello,
 
  I have connected AP-30 directly to the one of the seperate interface of Astaro. When we try to connect Ap-30 without Vlan configuration it works fine but when we configure vlan on the interface and try to connect AP-30 it does not get ip address from the ASG. 

We are using Astaro Security Gateway 8.103. 

Please guide me through here. 

Thanks,
Dhyanesh


This thread was automatically locked due to age.
Parents
  • 0
    Wowwwwwwwwww  Helmut.
    Thanks for ur help.. I just followed ur steps.. Connected AP to eth no vlan then enabled vlan tagging.. let the configuration push into AP.. waited for sometime and then enabled vlan on that interface and boom.... it got the configuration and AP got working... 
    Thanks a lot again for helping...appreciated 

    Regards,
    Dhyanesh
  • 0 in reply to dhyanesh.mehta
    Great!

    Just for information:

    As long as VLAN tagging is enabled the AP will always try to connect to the ASG via VLAN but will fall back to plain ethernet if the ASG is not found on the configured VLAN.

    Helmut
Reply Children
No Data
Unfiltered HTML