This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Innactive Ap30

HI,

Those are the necessary points:

So, please make sure that either
1) the ASG sits in the upstream of the APs
2) the ASG is the default gateway
3) the default gateway routes frames with dst 1.2.3.4/2712 to the ASG

Who can explain to me the 3rd point?

Regards

This thread was automatically locked due to age.

0 hschaa over 13 years ago

In your setup the default gateway (which is not the ASG) needs to redirect frames to the destination IP 1.2.3.4, port 1712 to the IP of the ASG interface in order to allow a connection between the AP and the ASG (Nevertheless I don't understand why you can't make the ASG the default gateway and reroute frames to your external router).

I don't know your router and as such can't help you with this, you might want to consult the router manual.

Helmut
Cancel
Vote Up 0 Vote Down

Cancel
0 equintana over 13 years ago

At my default gateway... you mean the cisco router, don´t you?
Cancel
Vote Up 0 Vote Down

Cancel
0 hschaa over 13 years ago in reply to equintana

At my default gateway... you mean the cisco router, don´t you?

This is correct.
Cancel
Vote Up 0 Vote Down

Cancel
0 equintana over 13 years ago

Today´s afternoon, I´m going to reset to factory and and step by step a new config to ensure a fine config
Cancel
Vote Up 0 Vote Down

Cancel
0 hschaa over 13 years ago in reply to equintana

I meant is there a second DHCP server attached to the LAN that is not the ASG?
Cancel
Vote Up 0 Vote Down

Cancel