Hello,
i want to implement an Unifii AP-AC Pro in my network environment and get stuck to get it working.
Controller and AP are in the same network (10.10.0.xxx, vlan 10) and i can access the AP from the Unifi Software.
The UTM is on the same vlan 10
I created an interface on the UTM with the ip-address 172.16.29.1/24 linked to a vlan id 201, an dhcp server that should deploy IPs from 172.16.29.100 to 172.16.29.200 and a masquerading rule to the modem interface.
Then, i went over to the Unifi configuration and created a wireless network "Guest" and ticked the option vlan to vlan id 201.
At least i configured the switch:
Switch 2 Port d16 -> there is the ap connected -> set as trunk port == trk16
Switch 1 Port A21 - > there is the UTM connected -> set as trunk port trk21
trk1 on both switches are for the uplink to the other switch
vlan 201 -> vlan-Unifi
switch 2 trk16 -> tagged vlan 201, untagged vlan 10
switch 2 trk1 -> tagged vlan 201, vlan 10
switch 1 trk21 -> tagged vlan 201
switch1 trk1 -> tagged vlan 201, vlan 10
i don`t get an ip address when i try to connect a wireless device to the broadcasted wifi network via dhcp.
When i set a static ip address i am connected to the AP but i can`t access anything.
So i think there is still something wrong with the switch configuration but i can`t figure it out.
Maybe someone here could help?
This thread was automatically locked due to age.