This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Web Filtering in Bridge mode with authentication

Hi All.

I stuck setting up my UTM. The goal is to have in-line Web Filtering with authentication. Similar to what Barracuda Web Filter has.

My network is:
-- --
On the Bridge Interface Default GW is set to router IP (10.0.0.1)

Web Filter is in Full Transparent mode. Default Authentication: Browser.
Allowed Networks: Any
Firewall Rule Any-Any-Allow active

IE or Firefox getting connection timeout. Without asking my Username/Password

Any help appreciated.

This thread was automatically locked due to age.

Parents

0 Scott_Klassen over 9 years ago

The UTM expects each physical network port to be assigned to separate subnets unless they are part of a bridge or LAG.

__________________
ACE v8/SCA v9.3

...still have a v5 install disk in a box somewhere.

http://xkcd.com
http://www.tedgoff.com/mb
http://www.projectcartoon.com/cartoon/1
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Scott_Klassen over 9 years ago

The UTM expects each physical network port to be assigned to separate subnets unless they are part of a bridge or LAG.

__________________
ACE v8/SCA v9.3

...still have a v5 install disk in a box somewhere.

http://xkcd.com
http://www.tedgoff.com/mb
http://www.projectcartoon.com/cartoon/1
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 adiomin over 9 years ago in reply to Scott_Klassen

Thank you!
Cancel
Vote Up 0 Vote Down

Cancel