This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Defaulting to base policy

I'm hoping someone can help me figure out where I went wrong with setting up.

I've followed the instructions here:

Fastvue Sophos Reporter Sophos UTM and Active Directory Step by Step Integration Guide

When doing policy tests and with users, I'm finding that everything is defaulting to base policy. If I set base policy to admin level, everyone gets unrestricted access. If I set it to most restrictive, everyone is blocked.

AD SSO in standard mode
Firmware version: 9.315-2

Thanks

This thread was automatically locked due to age.

0 rsenio over 9 years ago

I am seeing the same thing but only with the built in Policy Helpdesk. One filter profile set to standard mode, AD auth and time schedule policies. Clients get DHCP 252 and browsing works as it should, including the schedule.

Default filter profile is still set with no auth, and only the major problem categories blocked. This is used when the bridged guest network surfs, no DHCP 252. This also works.

The policy helpdesk errors if I do not specify a user (as it should because it is looking at the correct profile) Once I enter a user and time to test a KNOWN blocked site based on schedule, it tests it against the correct filter profile but wrong policy.
Cancel
Vote Up 0 Vote Down

Cancel
0 BAlfson over 9 years ago

How is your configuration different from HTTP-S Proxy Access with AD-SSO?

Cheers - Bob

Sophos UTM Community Moderator
Sophos Certified Architect - UTM
Sophos Certified Engineer - XG
Gold Solution Partner since 2005

MediaSoft, Inc. USA
Cancel
Vote Up 0 Vote Down

Cancel